|
Child Hand Mold, Foot Casting Kit, Child Hand Casting, Child Hand Cast Molding Kit
Product Details:
Finish Choices: (listed in the order shown in the feet picture below) unfinished (for comparison), clear semi-matte sealant, clear glaze, pearl or bronze. [Note: both the glaze and the matte sealant can be used as a top coat over other paints.]
This kit contains the materials to do 2 complete castings of a child over the age of 1 (or when the infant kit is too small, which would be foot over the length of 4 inches). You can therefore cast either two feet, two hands or one hand & one foot. ["Refills" (casting powders only) to create additonal statues can be added to this complete kit at a discount- see selections above.]
This kit can also be used to cast baby's bottom. See our gallery for a photo slide show of this process.
The larger molding tray and generous amounts casting materials included with this kit can accommodate a foot up to about a child shoe size 10 and/or a hand up to about age 4 with the included tray. However, if a flexible large cup-shaped container is used instead (not included), the materials can accommodate a hand up to about age 10. [The total length of the container is 7 inches and it is 4 inches deep.]
Clear Glaze Pearl Bronze Semi-Matte Mounted Matte
    
^ Click on above images to enlarge. ^
View More Casting Examples Here
How is a 3D casting made? Mix the molding powder with water (cool setting, nontoxic & non allergenic) and insert the foot or hand. Hold baby's foot or hand in ther material for about 45-60 seconds. A foot-shaped molding container is supplied and wiggling is not a problem as long as your child's foot or hand remains submerged in the molding material until it sets. Remove foot or hand leaving behind a negative 3D mold. That mold is then filled with casting stone. Once hardened, the molding material is peeled away to reveal the stone staue. Note: Your child never comes into contact with casting stone. General Photo Instructions
See our Case Packs category to save up to 40% on a 9-pack of this kit plus get free shipping within the U.S!
 Included: 2 pkgs molding powder, 2 pkgs casting stone, 1 reusable molding container, mixing spoon, paint brush, choice of finish, sandpaper, detailing pin and complete instructions.
There are also a variety of display cases to choose from.
Finish Choices: (Some sort of finish is recommended to keep out dirt and oil, etc.) The clear glaze is a water based triple-thick formula that goes on smoothly with no brush strokes and usually requires only 1 thin coat. It lends a bright, clear coating that gives the illusion of depth and creates a glazed ceramic look. The clear semi-matte sealant is water-based, goes on white and dries to a clear semi-matte finish. It can also be applied over other paints. The paints are nontoxic metallic acrylics that are especially designed for bisques, ceramics and plasters.
Other items you will need (not included): bowl for mixing casting stone, liquid measuring cup and (optionally) a flexible plastic cup for a hand casting
Optional Items: permanent marker for monogramming, clear coat varnish finish to go over bronzing paint (recommended if the statue will be handled a lot)
[Also suggested for 2 baby bottom / butt castings or combine the 2 sets of materials for a single adult foot (up to about a womens 8 or a larger foot if you do not need to include the ankle in the casting). Regarding the adults, you would need to supply your own bread loaf shaped container or plastic lined shoe box.]
 |
Customers who purchased this also purchased the following: |
 |
|
3D Life Casting Kits
